Break IC, Recover MCU, Microcontroller Reverse Engineering

Posts Tagged ‘copy microcontroller embedded firmware’

Copy Microcontroller PIC16F627A Software

We can Copy Microcontroller PIC16F627A Software, please view below Microcontroller PIC16F627A/628A features for your reference:

High-Performance RISC CPU:

Low-Power Features:

Operating speeds from DC – 20 MHz

Interrupt capability

8-level deep hardware stack

Direct, Indirect and Relative Addressing modes

35 single-word instructions:

– All instructions single cycle except branches

· Standby Current:

– 100 nA @ 2.0V, typical

· Operating Current:

– 12 ìA @ 32 kHz, 2.0V, typical

– 120 ìA @ 1 MHz, 2.0V, typical

· Watchdog Timer Current

– 1 ìA @ 2.0V, typical

Special Microcontroller Features:

· Internal and external oscillator options:

– Precision internal 4 MHz oscillator factory calibrated to ±1%

– Low-power internal 48 kHz oscillator

– External Oscillator support for crystals and resonators

· Power-saving Sleep mode to faciliate MCU Cracking

· Programmable weak pull-ups on PORTB

· Multiplexed Master Clear/Input-pin

· Watchdog Timer with independent oscillator for reliable operation

· Low-voltage programming

· In-Circuit Serial Programming™ (via two pins)

· Programmable code protection

· Brown-out Reset

· Power-on Reset

· Power-up Timer and Oscillator Start-up Timer

· Wide operating voltage range (2.0-5.5V)

· Industrial and extended temperature range

· High-Endurance Flash/EEPROM cell:

– 100,000 write Flash endurance

– 1,000,000 write EEPROM endurance

– 40 year data retention

· Timer1 Oscillator Current:

– 1.2 ìA @ 32 kHz, 2.0V, typical

· Dual-speed Internal Oscillator:

– Run-time selectable between 4 MHz and 48 kHz

– 4 ìs wake-up from Sleep, 3.0V, typical

Peripheral Features:

· 16 I/O pins with individual direction control

· High current sink/source for direct LED drive

· Analog comparator module with:

– Two analog comparators

– Programmable on-chip voltage reference (VREF) module

– Comparator outputs are externally accessible

· Timer0: 8-bit timer/counter with 8-bit programmable prescaler

· Timer1: 16-bit timer/counter with external crystal/ clock capability

· Timer2: 8-bit timer/counter with 8-bit period register, prescaler and postscaler

· Capture, Compare, PWM module:

– 16-bit Capture/Compare

– 10-bit PWM

· Addressable Universal Synchronous/Asynchronous Receiver/Transmitter USART/SCI