Break IC, Recover MCU, Microcontroller Reverse Engineering

Posts Tagged ‘атакувам интегрална схема entsrapted firmware’

Attack MCU PIC16CE625 locked memory and extract program from Microcontroller PIC16CE625 flash memory, disable the security fuse bit after crack Microprocessor PIC16CE625 so the microprobes will be able to get access to the internal memory

Attack MCU PIC16CE625 locked memory and extract program from Microcontroller PIC16CE625 flash memory, disable the security fuse bit after crack Microprocessor PIC16CE625 so the microprobes will be able to get access to the internal memory;

Interrupt capability 16 special function hardware registers

8-level deep hardware stack

Direct, Indirect and Relative addressing modes

Peripheral Features:

· 13 I/O pins with individual direction control

· High current sink/source for direct LED drive

· Analog comparator module with:

– Two analog comparators

– Programmable on-chip voltage reference (VREF) module

– Programmable input multiplexing from device inputs and internal voltage reference

– Comparator outputs can be output signals

· Timer0: 8-bit timer/counter with 8-bit programmable prescaler

Special Microcontroller Features:

· In-Circuit Serial Programming (ICSP™) (via two pins)

· Power-on Reset (POR)

· Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)

· Brown-out Reset

· Watchdog Timer (WDT) with its own on-chip RC oscillator for reliable operation

Special Microcontroller Features (cont’d)

· 1,000,000 erase/write cycle EEPROM data memory

· EEPROM data retention > 40 years

· Programmable code protection

· Power saving SLEEP mode

· Selectable oscillator options

· Four user programmable ID locations

CMOS Technology:

· Low-power, high-speed CMOS EPROM/EEPROM technology

· Fully static design

· Wide operating voltage range – 2.5V to 5.5V

· Commercial, industrial and extended temperature range

· Low power consumption

– < 2.0 mA @ 5.0V, 4.0 MHz

– 15 mA typical @ 3.0V, 32 kHz

– < 1.0 mA typical standby current @ 3.0V