We can reverse engineering Atmel MCU ATTINY48 heximal, please view the Atmel MCU ATTINY48 features for your reference:
· High-performance, Low-power AVR® 8-bit Atmel MCU
· Advanced RISC Architecture
– 90 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General Purpose Working Registers
– Fully Static Operation
Nonvolatile Program and Data Memories
– 1K Byte In-System Programmable Flash Program Memory
Endurance: 1,000 Write/Erase Cycles
– 64 Bytes EEPROM
Endurance: 100,000 Write/Erase Cycles
– Programming Lock for Flash Program Data Security before Reverse Engineering Atmel MCU ATtiny48 Heximal
Peripheral Features
– Interrupt and Wake-up on Pin Change
– Two 8-bit Timer/Counters with Separate Prescalers
– One 150 kHz, 8-bit High-speed PWM Output
– 4-channel 10-bit ADC
One Differential Voltage Input with Optional Gain of 20x
– On-chip Analog Comparator
– Programmable Watchdog Timer with On-chip Oscillator
Special Atmel MCU Features
– In-System Programmable via SPI Port
– Enhanced Power-on Reset Circuit
– Programmable Brown-out Detection Circuit if Reverse Engineering Atmel MCU ATtiny48 Heximal
– Internal, Calibrated 1.6 MHz Tunable Oscillator
– Internal 25.6 MHz Clock Generator for Timer/Counter
– External and Internal Interrupt Sources
– Low-power Idle and Power-down Modes
Power Consumption at 1.6 MHz, 3V, 25°C
– Active: 3.0 mA
– Idle Mode: 1.0 mA
– Power-down: < 1 µA
I/O and Packages
– 8-lead PDIP and 8-lead SOIC: 6 Programmable I/O Lines
Operating Voltages
– 2.7V – 5.5V
Internal 1.6 MHz System Clock
The ATtiny15L is a low-power CMOS 8-bit Atmel MCU based on the AVR RISC architecture if reverse engineering microcontroller.
By executing powerful instructions in a single clock cycle, the ATTINY48 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.