Restoring ARM Microcontroller STM32F103C4 Flash Binary

Restoring ARM Microcontroller STM32F103C4 Flash Binary after crack locked mcu stm32f103c4 security fuse bit and copy extracted firmware to new Microcontroller;

The temperature sensor has to generate a voltage that varies linearly with temperature to Recover MCU content. The conversion range is between 2 V < VDDA < 3.6 V. The temperature sensor is internally connected to the ADC1_IN16 input channel which is used to convert the sensor output voltage into a digital value.

The ARM SWJ-DP Interface is embedded, and is a combined JTAG and serial wire debug port that enables either a serial wire debug or a JTAG probe to be connected to the target of STMicro STM32F101RB MCU flash memory breaking. The JTAG TMS and TCK pins are shared respectively with SWDIO and SWCLK and a specific sequence on the TMS pin is used to switch between JTAG-DP and SW-DP.

Unless otherwise specified the minimum and maximum values in the process of Unlock ARM Base STM32F101CB Microprocessor are guaranteed in the worst conditions of ambient temperature, supply voltage and frequencies by tests in production on 100% of the devices with an ambient temperature at TA = 25 °C and TA = TAmax (given by the selected temperature range).

Data based on characterization results, design simulation and/or technology characteristics are indicated in the table footnotes and are not tested in production. Based on characterization, the minimum and maximum values refer to sample tests and represent the mean value plus or minus three times the standard deviation (mean±3S).

Unless otherwise specified, typical data are based on TA = 25 °C, VDD = 3.3 V (for the 2 V £ VDD £ 3.6 V voltage range). They are given only as design guidelines and are not tested.