Site icon Break IC, Recover MCU, Microcontroller Reverse Engineering

Recover MCU PIC16F627A Dump

Recover MCU PIC16F627A Dump

Unstand the CPU structure can help us better and faster Recover MCU PIC16F627A Dump from its memory:

High Performance RISC CPU:

Operating speeds from DC – 20 MHz when recover mcu

Interrupt capability

8-level deep hardware stack

Direct, Indirect and Relative Addressing modes 35 single word instructions

– All instructions single cycle except branches Special Microcontroller Features:

· Internal and external oscillator options

– Precision Internal 4 MHz oscillator factory calibrated to ±1%

– Low Power Internal 37 kHz oscillator

– External Oscillator support for crystals and resonators

· Power saving SLEEP mode

· Programmable weak pull-ups on PORTB

· Multiplexed Master Clear/Input-pin

· Watchdog Timer with independent oscillator for reliable operation

· Low voltage programming

· In-Circuit Serial Programming™ (via two pins)

· Programmable code protection

· Brown-out Reset

· Power-on Reset if recover mcu

· Power-up Timer and Oscillator Start-up Timer

· Wide operating voltage range. (2.0 – 5.5V)

· Industrial and extended temperature range

· High Endurance FLASH/EEPROM Cell

– 100,000 write FLASH endurance

– 1,000,000 write EEPROM endurance

– 100 year data retention

Low Power Features:

· Standby Current:

– 100 nA @ 2.0V, typical

· Operating Current:

– 12 µA @ 32 kHz, 2.0V, typical

– 120 µA @ 1 MHz, 2.0V, typical

· Watchdog Timer Current

– 1 µA @ 2.0V, typical

· Timer1 oscillator current:

– 1.2 µA @ 32 kHz, 2.0V, typical

· Dual Speed Internal Oscillator:

– Run-time selectable between 4 MHz and 37 kHz

– 4 µs wake-up from SLEEP, 3.0V

Peripheral Features:

· 16 I/O pins with individual direction control

· High current sink/source for direct LED drive

· Analog comparator module with:

– Two analog comparators

– Programmable on-chip voltage reference (VREF) module

– Selectable internal or external reference

– Comparator outputs are externally accessible

· Timer0: 8-bit timer/counter with 8-bit programmable prescaler

· Timer1: 16-bit timer/counter with external crystal/clock capability

· Timer2: 8-bit timer/counter with 8-bit period register, prescaler and postscaler

· Capture, Compare, PWM module

– 16-bit Capture/Compare

– 10-bit PWM

· Addressable Universal Synchronous/Asynchronous Receiver/Transmitter USART/SCI

Exit mobile version