Freescale SPC56EL70L3 Microprocessor Flash Program Breaking is a process to disable its tamper resistance system and readout microprocessor nxp spc56el70l3 flash memory program;

• High-performance e200z4d dual core
  • 32-bit Power Architecture® technology CPU
  • Core frequency as high as 120 MHz
  • Dual issue five-stage pipeline core
  • Variable Length Encoding (VLE)
  • Memory Management Unit (MMU)
  • 4 KB instruction cache with error detection code
  • Signal Processing Engine (SPE)
• Memory available
  • 2 MB flash memory with ECC
  • 192 KB on-chip SRAM with ECC
  • Built-in RWW capabilities for EEPROM emulation
• SIL3/ASILD innovative safety concept: Lock step mode and Fail-safe protection
  • Sphere of Replication (SoR) for key components (such as CPU core, eDMA, crossbar switch)
  • Fault Collection and Control Unit (FCCU)
  • Redundancy Control and Checker Unit (RCCU) on outputs of the SoR connected to FCCU
  • Boot-time Built-In Self-Test for Memory (MBIST) and Logic (LBIST) triggered by hardware
  • Boot-time Built-In Self-Test for ADC and flash memory triggered by software which can be applied for recover nxp spc5603bk03 microcomputer flash file;

Replicated safety enhanced watchdog

• Replicated junction temperature sensor
  • Non Maskable Interrupt (NMI)
  • 16-region Memory Protection Unit (MPU)
  • Clock Monitoring Units (CMU)
  • Power Management Unit (PMU)
  • Cyclic Redundancy Check (CRC) unit
• Decoupled Parallel mode for high performance use of replicated cores
• Nexus Class 3+ interface
• Interrupts
  • Replicated 16-priority controller
  • Replicated 16-channel eDMA controller
• GPIOs individually programmable as input, output or special function
• Three 6-channel general-purpose eTimer units can be used for restoring microcomputer spc5603ck0c flash content
• 2 FlexPWM units: Four 16-bit channels per module
• Communications interfaces
  • 2 LINFlexD channels
  • 3 DSPI channels with automatic chip select generation
  • 3 FlexCAN interfaces (2.0B Active) with 32 message objects
  • FlexRay module (V2.1 Rev. A) with 2 channels, 64 message buffers and data rates up to 10 Mbit/s
• Two 12-bit Analog-to-digital Converters (ADC)
  • 16 input channels
  • Programmable Cross Triggering Unit (CTU) to synchronize ADCs conversion with timer and PWM
• Sine wave generator (D/A with low pass filter)
• On-chip CAN/UART/FlexRay Bootstrap loader
• Single 3.0 V to 3.6 V voltage supply
• Ambient temperature range –40 °C to 125 °C

Junction temperature range –40 °C to 150 °C

Comments are closed.