Site icon Break IC, Recover MCU, Microcontroller Reverse Engineering

Copy Microcontroller PIC16F627A Software

Copy Microcontroller PIC16F627A Software

Copy Microcontroller PIC16F627A Software

We can Copy Microcontroller PIC16F627A Software, please view below Microcontroller PIC16F627A/628A features for your reference:

High-Performance RISC CPU:

Low-Power Features:

Operating speeds from DC – 20 MHz

Interrupt capability

8-level deep hardware stack

Direct, Indirect and Relative Addressing modes

35 single-word instructions:

– All instructions single cycle except branches

· Standby Current:

– 100 nA @ 2.0V, typical

· Operating Current:

– 12 ìA @ 32 kHz, 2.0V, typical

– 120 ìA @ 1 MHz, 2.0V, typical

· Watchdog Timer Current

– 1 ìA @ 2.0V, typical

Special Microcontroller Features:

· Internal and external oscillator options:

– Precision internal 4 MHz oscillator factory calibrated to ±1%

– Low-power internal 48 kHz oscillator

– External Oscillator support for crystals and resonators

· Power-saving Sleep mode to faciliate MCU Cracking

· Programmable weak pull-ups on PORTB

· Multiplexed Master Clear/Input-pin

· Watchdog Timer with independent oscillator for reliable operation

· Low-voltage programming

· In-Circuit Serial Programming™ (via two pins)

· Programmable code protection

· Brown-out Reset

· Power-on Reset

· Power-up Timer and Oscillator Start-up Timer

· Wide operating voltage range (2.0-5.5V)

· Industrial and extended temperature range

· High-Endurance Flash/EEPROM cell:

– 100,000 write Flash endurance

– 1,000,000 write EEPROM endurance

– 40 year data retention

· Timer1 Oscillator Current:

– 1.2 ìA @ 32 kHz, 2.0V, typical

· Dual-speed Internal Oscillator:

– Run-time selectable between 4 MHz and 48 kHz

– 4 ìs wake-up from Sleep, 3.0V, typical

 

Peripheral Features:

· 16 I/O pins with individual direction control

· High current sink/source for direct LED drive

· Analog comparator module with:

– Two analog comparators

– Programmable on-chip voltage reference (VREF) module

– Comparator outputs are externally accessible

· Timer0: 8-bit timer/counter with 8-bit programmable prescaler

· Timer1: 16-bit timer/counter with external crystal/ clock capability

· Timer2: 8-bit timer/counter with 8-bit period register, prescaler and postscaler

· Capture, Compare, PWM module:

– 16-bit Capture/Compare

– 10-bit PWM

· Addressable Universal Synchronous/Asynchronous Receiver/Transmitter USART/SCI

Exit mobile version