Break STM8S103F3P3 Micro CPU Flash Memory will help engineer make stm8s103f3p3 mcu flash code cloning, the original heximal will be extracted from embedded flash and eeprom memory;
The window watchdog is used to detect the occurrence of a software fault, usually generated by external interferences or by unexpected logical conditions, which cause the application program to abandon its normal sequence.
The window function can be used to trim the watchdog behavior to match the application perfectly after stm8s003k3 microcontroller flash memory recovery.
romper la memoria flash de la CPU del microcontrolador STM8S103F3P3 ayudará al ingeniero a hacer clonación de código flash MCU stm8s103f3p3, el heximal original se extraerá de la memoria flash y eeprom integrada;
The application software must refresh the counter before time-out and during a limited time window.
A reset is generated in two situations:
Timeout: at 16 MHz CPU clock the time-out period can be adjusted between 75 µs up to 64 ms.
Refresh out of window: the down-counter is refreshed before its value is lower than the one stored in the window register.
The independent watchdog peripheral can be used to resolve processor malfunctions due to hardware or software failures which can be used for copying stm8s003f3 microprocessor flash content.
It is clocked by the 128 kHz LSI internal RC clock source, and thus stays active even in case of a CPU clock failure
The IWDG time base spans from 60 µs to 1 s.