Break Microcontroller PIC16F767 Firmware

Break Microcontroller PIC16F767 protected memory include flash and eeprom area, readout embedded firmware from MCU PIC16F767 memory in the format of heximal and recover the file to blank MCU PIC16F767;

Low-Power Features:

· Power-Managed modes:

– Primary Run (XT, RC oscillator, 76 µA,

1 MHz, 2V)

– RC_RUN (7 µA, 31.25 kHz, 2V)

– SEC_RUN (9 µA, 32 kHz, 2V)

– Sleep (0.1 µA, 2V)

· Timer1 Oscillator (1.8 µA, 32 kHz, 2V)

· Watchdog Timer (0.7 µA, 2V)

· Two-Speed Oscillator Start-up Oscillators:

· Three Crystal modes: – LP, XT, HS (up to 20 MHz)

· Two External RC modes

· One External Clock mode: – ECIO (up to 20 MHz)

· Internal Oscillator Block:

– 8 user-selectable frequencies (31 kHz, 125 kHz, 250 kHz, 500 kHz, 1 MHz, 2 MHz, 4 MHz, 8 MHz)

Analog Features:

· 10-bit, up to 14-channel Analog-to-Digital Converter

– Programmable Acquisition Time

– Conversion available during Sleep mode

· Dual Analog Comparators

· Programmable Low-Current Brown-out Reset (BOR) Circuitry and Programmable Low-Voltage Detect (LVD)

Peripheral Features:

· High Sink/Source Current: 25 mA

· Two 8-bit Timers with Prescaler

· Timer1/RTC module:

– 16-bit timer/counter with prescaler

– Can be incremented during Sleep via external 32 kHz watch crystal

· Master Synchronous Serial Port (MSSP) with 3-wire SPITM and I2CTM (Master and Slave) modes

· Addressable Universal Synchronous Asynchronous Receiver Transmitter (AUSART)

· Three Capture, Compare, PWM modules:

– Capture is 16-bit, max. resolution is 12.5 ns

– Compare is 16-bit, max. resolution is 200 ns

– PWM max. resolution is 10 bits

· Parallel Slave Port (PSP) – 40/44-pin devices only

Special Microcontroller Features:

· Fail-Safe Clock Monitor for protecting critical applications against crystal failure

· Two-Speed Start-up mode for immediate code execution

· Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)

· Programmable Code Protection

· Processor Read Access to Program Memory

· Power-Saving Sleep mode

· In-Circuit Serial Programming (ICSP) via two pins

· MPLAB® In-Circuit Debug (ICD) via two pins

· MCLR pin function replaceable with input only pin