Break DSP Microcontroller TMS320F240 Locked Flash Memory and extract embedded IC code from its flash memory, clone extracted firmware to new MCU tms320f240pg for perfect cloning;

Timing parameter symbols used are created in accordance with JEDEC Standard 100. To shorten the symbols, some of the pin names and other related terminology have been abbreviated as follows:

a                   access time                                                               

H                  High

• cycle time (period)                                                    L                   Low
• delay time                                                                   V                   Valid

f                    fall time                                                                       X                   Unknown, changing, or don’t care level

h                   hold time                                                                    Z                   High impedance r                                                                                    rise time

su                 setup time

t                    transition time

• valid time
• pulse duration (width)

All output signals from the 28x devices (including XCLKOUT) are derived from an internal clock such that all output transitions for a given half-cycle occur with a minimum of skewing relative to each other when break dsp mcu tms320f28063 flash memory.

The signal combinations shown in the following timing diagrams may not necessarily represent actual cycles. For actual cycle examples, see the appropriate cycle description section of this document.

This test load circuit is used to measure all switching characteristics provided in this document.

Comments are closed.